Dell PowerConnect M8024 - Access Control Group

212 Configuring System Information
Removing SNMP Views
1. Open the SNMP View Settings p age .
2. Click Show All .
The
View Table page displays.
3. Select an SNMP view.
4. Check the Remove check box.
5. Click Apply Changes .
The SNMP view is removed, and the device is updated.
Defining SNMP Views Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• SNMP Commands.
Access Control Group
Use the Access Control Group page to view information for creating SNMP groups, and to assign SNMP
access privileges. Groups allow network managers to assign access rights to specific device features or
features aspects.
To display the Access Control Group page, click System > SNMP > Access Control in the tree view
.