184 Configuring System Information
Configuring the Telnet Server Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Telnet Server Commands
Denial of Service
Denial of Service refers to the exploitation of a variety of vulnerabilities which would interrupt the
service of a host or make a network unstable. Use the Denial of Service page to configure settings to help
prevent denial of service attacks.
To display the Denial of Service page, click System > Management Security > Denial of Service in the
tree view.
Figure 6-67. Denial of Service
The Denial of Service page contains the following fields:
•
Denial of Service SIP=DIP
— Enabling SIP=DIP DoS prevention causes the switch to drop packets
that have a source IP address equal to the destination IP address.
•
Denial of Service First Fragment
— Enabling First Fragment DoS prevention causes the switch to
drop packets that have a TCP header smaller than the configured minimum TCP header size (Min
TCP Hdr Size).
To Next Page
Loading...
