Configuring Switching Information 355
Enabling Bridge Multicast Filtering on the Switch
1.
Open the
Multicast Global Parameters
page.
2.
Select
Enable
in the
Bridge Multicast Filtering
field.
3.
Click
Apply Changes
.
Bridge Multicast
is enabled on the switch.
Enabling Multicast Forwarding and/or IGMP Snooping Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Address Table Commands
Bridge Multicast Group
Use the
Bridge Multicast Group
page
to create new multicast service groups or to modify ports and
LAGs assigned to existing multicast service groups. Attached interfaces display in the Port and LAG
tables, and reflect the manner in which each is joined to the Multicast group.
To display the Bridge Multicast Group
page, click Switching > Multicast Support > Bridge Multicast
Group in the tree view.
To Next Page
Loading...
