Dell PowerConnect M8024 - Page 365

Configuring Switching Information 363
Modifying IGMP Snooping Settings for Multiple Ports, LAGs, or VLANs
1. Open the General IGMP snooping page.
2. Click Show All .
The
IGMP Snooping Table displays.
3. Click Edit for each Port, LAG, or VLAN to modify.
4. Edit the IGMP Snooping fields as needed.
5. Click Apply Changes .
The IGMP Snooping settings are modified, and the device is updated.
Copying IGMP Snooping Settings to Multiple Ports, LAGs, or VLANs
1. Open the General IGMP snooping page.
2. Click Show All .
The
IGMP Snooping Table displays.
3. Click Copy Parameters From .
4. Select a Unit/Port, LAG, or VLAN to use as the source of the desired parameters.
5. Click Copy To for the Unit/Ports, LAGs, or VLANs that these parameters will be copied to.
6. Click Apply Changes .
The IGMP Snooping settings are modified, and the device is updated.
Configuring General IGMP Snooping Settings with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• IGMP Snooping Commands
Global Querier Configuration
Use the Global Querier Configuration page to configure the parameters for the IGMP Snooping
Querier.
To display the Global Querier Configuration
page, click Switching > Multicast Support > IGMP
Snooping > Global Querier Configuration in the tree view.