Dell PowerConnect M8024 - Page 593

Configuring IPv6 591
Figure 10-20. OSPFv3 Area Configuration - NSSA
5. Complete the remaining fields.
6. Click Apply Changes .
The NSSA information is saved and the device is updated.
Deleting OSPFv3 Stub Area Information
1. Open the OSPFv3 Area Configuration page with configured Stub Area information.
2. Click Delete Stub Area .
3. Click Apply Changes .
Deleting OSPFv3 NSSA Information
1. Open the OSPFv3 Area Configuration page with configured NSSA information.
2. Click NSSA Delete .
3. Click Apply Changes .
Configuring OSPFv3 Area using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• OSPFv3 Commands