Dell PowerConnect M8024 - Page 611

Configuring IPv6 609
Creating a New Virtual Link
1. Open the OSPFv3 Virtual Link Configuration page.
2. Select Create New Virtual Link from the drop-down menu to define a new virtual link.
3. Enter the Neighbor Router ID .
4. Click Create .
The new link is created, and you are returned to the Virtual Link Configuration page.
Configuring a Virtual Link
1. Open the OSPFv3 Virtual Link Configuration page.
2. Select the virtual link to configure.
3. Modify the remaining fields as needed.
4. Click Apply Changes .
5. The virtual link is configured for OSPFv3, and the device is updated.
Configuring an OSPFv3 Virtual Link using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• OSPFv3 Commands