Configuring IP Multicast 653
The Multicast Global Configuration page contains the following fields:
•
Admin Mode
— Select Enable or Disable to set the administrative status of Multicast Forwarding in
the router. The default is Disable.
•
Protocol State
— The operational state of the multicast forwarding module.
•
Table Maximum Entry Count
— The maximum number of entries in the IP Multicast routing table.
•
Number Of Packets For Which Source Not Found
— The number of multicast packets that were
supposed to be routed but which failed the RPF check.
•
Number Of Packets For Which Group Not Found
— The number of multicast packets that were
supposed to be routed but for which no multicast route was found.
•
Protocol
— The multicast routing protocol presently activated on the router, if any.
•
Table Entry Coun t
— The number of multicast route entries currently present in the Multicast route
table.
•
Table Highest Entry Count
— The highest number of multicast route entries that have been present
in the Multicast route table.
To Next Page
Loading...
