Configuring Dell PowerConnect 69
Boot Menu May 25 2009
Select an option. If no selection in 10 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Boot Menu Version: 31 October 2007
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
7 - Update boot code
8 - Delete backup image
9 - Reset the system
10 - Restore configuration to factory defaults (delete config files)
11 - Activate Backup Image
12 - Password Recovery Procedure
[Boot Menu]
The boot process runs approximately 60 seconds.
The auto-boot message that appears at the end of POST (see the last lines) indicates that no problems
were encountered during boot. To return to operational code from the [Boot Menu] prompt, press 1.
The following output displays an example configuration. Items such as addresses, versions, and dates
may differ for each switch.
Operational Code Date: Tue May 26 14:12:20 2009
Uncompressing.....
To Next Page
Loading...
