Delta MH300 Series - Page 583

Chapter 12 Description of Parameter Settings
MH300
12.1-12-20
12-68
Tension Taper Curve Compensation Value
Default: 0
Settings 0–60000
12-69
Multi-step Taper Reel Diameter 1
Default: 6000.0
Settings 10.0–6000.0
12-70
Multi-step Taper Reel Diameter 2
Default: 6000.0
Settings 10.0–6000.0

12-71
Multi-step Taper Value 1
Default: 0
Settings 0–100

12-72
Multi-step Taper Value 2
Default: 0
Settings 0–100

12-73
Pre-drive Frequency Gain
Default: 0
Settings -50.0–50.0%
 When switching the reel during the operation, the pre-drive function is to rotate the rewind axle /
unwind axle in advance, and make the linear speed of the rotation and the material are the same
to prevent from a huge impact. When pre-drive terminal is valid, the drive automatically calculates
output frequency according to the linear speed and the reel diameter have been detected to match
their linear speed.

12-74
Pre-drive Acceleration Time
Default: 0
Settings 0–65535 sec.

12-75
Pre-drive Deceleration Time
Default: 0
Settings 0–65535 sec.