Denso BHT-1306BWB - Detailed Settings for Standard 2 of 5 (STF)

99
Barcode Handy Terminal
“8: STF”: Detailed settings for Standard 2 of 5 (STF)
1. Select “8: STF” at the SET BARCODE menu and then press the ENT
key.
The SET STF screen is displayed.
“1: MIN”:
Set minimum number of digits of STF.
Setting range: 1–99
“2: MAX”:
Set maximum number of digits of STF.
Setting range: 1–99
- Point - Make sure that the minimum number of digits is less than the maximum number of digits. I
f
the value of minimum number of digits is larger than the maximum number of digits, erro
r
occurs during the reading.
“3: CD CHECK”:
“ON”: Reading is performed only when the check digits are correct. Reading becomes
impossible if check digits are incorrect or missing.
“OFF”: Reading is performed regardless of the use of check digits.
“4: TYPE”:
“BOTH”: Enable both normal and short STF reading.
“NORMAL”: Enable normal STF reading.
“SHORT”: Enable short STF reading.
2. Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4]) to select the item to be set and
press the ENT key.
3. Use the cursor keys ([ ] [ ]) to select settings value.
4. Press the ENT key or BS/C key for the settings value to be valid and then return to the SET
BARCODE screen.