35
Barcode Handy
3.4 Changing the Default Settings
The volume, vibrator, LCD display brightness and power save settings can be changed at the MENU screen.
Item Details Setting
VOLUME
Used to set the volume of the speaker that notifies the user
when barcode scanning is complete.
The volume can be adjusted in 4 levels: Hi, Lo, Mid and Mute.
Mute → Lo → Mid → Hi
VIBRATOR
Used to turn ON/OFF the vibrator that notifies the user when
barcode scanning is complete.
ON, OFF
BRIGHTNESS
Used to set the backlight brightness of the LCD display.
The brightness can be adjusted in 5 levels.
Levels 1 to 5
BRIGHTNESS(PS)
Used to set the backlight brightness of the LCD display during
power save mode. The brightness can be adjusted in 6 levels.
Levels 0 to 5
POWER SAVE
Used to set the time until the LCD display backlight is dimmed
when not in use in order to save power.
1-second units
(max. 30 seconds)
ILLUMINATION
CONTROL
Used to set the pattern of illumination control in reading the
code.
BLINKING : The illumination blinks.
NO BLINKING : The illumination keeps lighting.
LOW POWER : The illumination is dimmed and blinks. This
may cause unreadable of code and lengthening of reading.
BLINKING
NO BLINKING
LOW POWER
3.4.1 Procedure
1. Hold down magic key M1 for at least 1 second.
The MENU screen displays
To Next Page
Loading...
