Denso BHT-1306BWB - Setting the User Program Execution Option; Resume

117
Barcode Handy Terminal
[9] Setting the user program execution option
Use the following procedure to set the user program execution option.
1. Select “1: EXEC PROG OPTION” at the SET SYSTEM 2/2 menu
and then press the ENT key.
The EXEC PROG OPTION screen appears.
The highlighted settings are the current settings.
2. Use the cursor keys ([▲] [▼]) or numeric keys ([1] [2]) to change
the setting and then press the ENT key.
Press the Backspace/clear key to return to the SET SYSTEM menu.
“1: RESUME”:
“ON”: Enables the resume function.
“OFF”: Disables the resume function.
“2: RESTART DIALOG”:
Sets the presence of the confirmation screen when the auto-start
execution program is re-launched. For the function where the
auto-start execution program is re-launched, refer to “4.3.6
Executing the Auto-start Execution Program from the Point of
Start-up”.
“ON”: The confirmation screen is displayed.
“OFF”: The confirmation screen is not displayed.
 Note  The resume function is used to return the BHT to the status (screen) when the BHT powe
r
was turned OFF previously.
EXEC PROG OPTION
1:RESUME
ON OFF
2:RESTART DIALOG
ON OFF
SET SYSTEM
2/2
1：EXEC PROG OPT
2：DRIVE TOOL
3：OPERATION LOG
4：IME
[◀] BACK