Denso BHT-1306BWB - Setting up the Slave Station

176
BHT-1300B series
 Setting up the slave station
1. Select “4: SLAVE” at the SET BLUETOOTH menu and then press
the ENT key.
The current settings are displayed.
[1: PASSKEY]: Sets up the Bluetooth
®
passkey for the slave station.
[2: TIMEOUT]: Sets up the timeout limit in seconds.
[3: SECURITY]: Sets up the security mode for the slave station.
Press and hold the BS/C key to return to the SET BLUETOOTH menu.
2. Use the cursor keys ([▲] [▼]) or numeric keys ([1] [2] [3]) to select
the menu and then press the ENT key.
Entry mode is activated and the cursor is displayed.
To set up the “3: SECURITY”, use the cursor keys ([◄] [►]) to highlight and set the desired setting.
3. Use the numeric and period (.) keys to enter the desired value.
“PASSKEY”: Up to 16 characters
“TIMEOUT”: Valid Range: 1-255, Default : 255 seconds
For the Bluetooth
®
passkey and the security mode details, refer to Chapter 5 “Communication” – 5.3
“Bluetooth
®
wireless communications”.
To switch the entry mode (between numeric and alphabet entries), press the SF key.
To delete a single character, press the BS/C key. To delete the entire entry, press and hold the BS/C key
or press the SF and BS/C keys simultaneously.
4. Press the ENT key.
5. Press and hold the BS/C key to return to the SET BLUETOOTH menu.