Denso BHT-1306BWB - Setting the Cradle (CU) or Irda Communication Parameters; Setting the Communication Parameters; Setting the Communication Protocol Options; Setting the Transmission Speed

101
Barcode Handy Terminal
 “1: COM1”: Setting the Cradle (CU) or IrDA communication
parameters
1. Select “1: COM1” at the SET COMMUNICATION menu and then press
the ENT key.
The SET SERIAL PORT <COM1> menu screen on the right is displayed.
2. Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3]) to highlight
“1: PARAMETER”, “2: PROTOCOL” or “3: DEVICE”, and then press
the ENT key.
Press and hold the BS/C key to return to the SET COMMUNICATION menu.
Setting the communication parameters
Select “1: PARAMETER” to display the screen on the right.
The highlighted setting is the current setting.
“1: TRANSMIT SPEED”: Setting the transmission speed
To change the setting, highlight the transmission speed with the cursor
keys ([◄] [►]) and press the ENT key.
Press and hold the BS/C key to return to the SET SERIAL PORT <COM1>
menu.
Setting the communication protocol options
Select “2: PROTOCOL” to display the screen on the right.
The highlighted setting is the current setting.
“1: SERIAL No.”:
Selects whether or not to add serial numbers to the data blocks.
“2: H.PARITY”:
Selects whether or not to add a horizontal parity.
“3: LINKUP TIME”:
Selects the timeout length (in seconds) to be applied when a link is
established.
“4: FIELD SPACE”:
Specifies handling of the trailing spaces at the end of the field.
Select “Ignore” to trim the trailing spaces or “Data” to retain them as data.
To make changes, use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4]) to highlight the item to
be set, highlight the setting value using the cursor keys ([◄] [►]), and then press the ENT key.
Press and hold the BS/C key to return to the SET SERIAL PORT <COM1> menu.
- Point - Selecting the BHT-Ir or YMODEM protocol ignores the serial number and horizontal parity
settings.
SET SERIAL PORT
< COM1 >
1：PARAMETER
2：PROTOCOL
3：DEVICE
SET PARAMETER
< COM1 >
1：TRANSMIT SPEED：
9600 19200
38400 57600
115200 460800
SET PROTOCOL
< COM1 >
1：SERIAL No. ：ON OFF
2：H.PARITY ：ON OFF
3：LINKUP TIME ：
None 30 60 90 120
4：FIELD SPACE ：
Ignore Data