87
Barcode Handy Terminal
[4] Setting the code scanning parameters
Use the following procedure to set the code scanning conditions.
1. Select “4: BARCODE” at the SET SYSTEM menu and then press the
ENT key.
The SET BARCODE screen on the right is displayed.
The highlighted display and displayed values will be the current settings.
1: DECODE SETTINGS:
The DECODE SETTINGS screen is displayed.
2: OPEN BAR SETTINGS:
The FUNCTION TO ASSIGN SCAN SETTINGS WITH THE SYSTEM
SETTINGS VALUE screen is displayed
2. Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2]) to highlight
the item to be set and press the ENT key.
Press the BS/C key to return to the SET SYSTEM menu.
“1: DECODE SETTINGS”: Code reading conditions and minimum number of digits for the
code to be read
1. Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4] [5] [6] )
to highlight the item to be set, highlight the setting value using the
cursor keys ([◄] [►]) and press the ENT key
.
Press the BS/C key to return to the SET BARCODE menu.
“1: INVERT”: Black/white inverted label reading function
Inverted barcode can be read.
“ON”: Enables black/white inverted label reading.
“OFF”: Disables black/white inverted label reading.
- Point - Auto-detect reading may take longer than ordinary reading
of black/white inverted labels or non-inverted labels.
To Next Page
Loading...
