Denso BHT-1306BWB - Wireless Security WPA2-PSK Mode

168
BHT-1300B series
 Wireless Security WPA2-PSK Mode
PSK authentication and an encryption system can be used with wireless security WPA2-PSK mode.
1. Select “2: CONFIGURATION” at the SET SECURITY menu and
then press the ENT key.
The screen on the right is displayed.
[1: AUTH PARAM (PSK)]: PSK authentication parameter setting
[2: WPA CIPHER]: Encryption system setting
Press and hold the BS/C key to return to the SET SECURITY menu.
2. Use the cursor keys ([▲] [▼]) or numerical key ([1]) to highlight [1:
AUTH PARAM (PSK)] and then press the ENT key.
The screen on the right is displayed.
[1: PRE SHARED KEY]: Sets the shared key.
3. Ensure that [1: PRE SHARED KEY] is highlighted and then press
the ENT key.
The mode changes to entry mode and the cursor is displayed.
4. Use the numerical keys to enter a shared key and press the ENT
key.
Press the SF key to change the entry mode (numerical entry (no guidance
display) and alphabet entry).
To delete a single character, press the BS/C key. To delete the entire entry,
press and hold the BS/C key, or press the SF key and BS/C key
simultaneously.
5. Press and hold the BS/C key to return to the SECURITY CONFIG
menu.
6. Use the cursor keys ([▲] [▼]) or numerical key ([2]) to highlight [2:
WPA CIPHER] and then press the ENT key.
The screen on the right is displayed.
[1: CIPHER MODE]: Selects TKIP or AES.
7. Ensure that [1: CIPHER MODE] is highlighted and then select TKIP or
AES.
Select TKIP to use TKIP.
Select AES to use AES.
8. Press the ENT key or BS/C key to return to the SECURITY CONFIG menu.