105
Barcode Handy Terminal
To make changes, use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4]) to highlight the item to
be set, highlight the setting value using the cursor keys ([◄] [►]), and then press the ENT key.
For “4: INTERVAL”, press the ENT key to change to entry mode.
The cursor is displayed, allowing the previous setting to be deleted by pressing the BS/C key.
Enter a new setting value with the numerical keys and press the ENT key.
Press and hold the BS/C key to return to the SET COMMUNICATION menu.
Select “3: BHT-Ir Protocol” at the PROTOCOL TYPE menu to display the
screen on the right.
Enter the ID number of the BHT using the numerical keys and then press
the ENT key. If there is no need to edit the current setting, press the ENT
key only.
- Point - The ID numbers shall be five-digit decimal numbers in the range from 00001 to 65534. If the
entered value is less than five digits, the ENT key is rejected.
If you have pressed a wrong key, use the BS/C key to delete it and then
enter the correct data.
Press and hold the BS/C key to return to the SET COMMUNICATION
menu.
To Next Page
Loading...
