Duplo DC-616 - Page 158

156
Chapter 7 6 HELP Mode
S2-Y1540
HELP Mode : 49
1. Function
2. Operating Procedure
(1) Margin and center slitter positions adjustment
• Positions of each margin (S1, S2) and center slitter (S3 – S6)
are adjusted.
(1) Margin and center slitter positions adjustment
1. Set the skew adjusting dial at “0”.
2. Access the HELP Mode “49”, and press the <START> key.
3. Cut the adjustment paper (S2-Y1040) by pressing the <TEST>
key.
* The paper is cut applying the Service person JOB84.
4. Measure the cut paper width.
5. Enter the adjustment value by pressing the NUMERIC key.
The slitter position moves by 0.1 mm when the adjustment value
is changed by 1.
H49 Slit adjust
XXX XXX XXX
XXX XXX XXX
JOB:MSL,SLOT3,4
The home position for the slitters 1, 3, and 5 is on the opposite side
of the control panel, while the home position for the slitters 2, 4, and
6 is on the control panel side.
IMPORTANT
6. Press the <SET> key, and store the adjustment information in the
memory.
7. Press the <STOP> key. It will return to the HELP Mode election
screen.
-0