155
Chapter 7 6 HELP Mode
7
S2-Y1540
HELP Mode : 48
1. Function
2. Operating Procedure
(1) Creasing depth adjustment
• The creasing depth is adjusted.
(1) Creasing depth adjustment
1. Set the skew adjusting dial at “0”.
2. Access the HELP Mode “48”, and press the <START> key.
3. Cut the adjustment paper by pressing the <TEST> key.
* The paper is cut applying the Service person JOB83.
4. Measure the fi nished creasing depth.
5. Select the desired depth by pressing the UP/DOWN cursor key.
6. Enter the adjustment value by pressing the NUMERIC key.
(0-150)
The slitter position moves by 0.1 mm when the adjustment value
is changed by 1.
H48 Crease depth
High Mid Low
XXX XXX XXX
SET:Save
The creasing depth is adjustable in 3-levels.
Thus the adjustment values shall be set to be HIGH > MID > LOW.
Reference depth: Total thickness - max. 0.4 - 0.45 (at 230gsm
sheet).
Creasing depth is reset to the default value by continuously
pressing the <C> key. (This is not a factory setting.)
IMPORTANT
IMPORTANT
7. Press the <STOP> key. It will return to the HELP Mode
selection screen.
-0
To Next Page
Loading...
