Duplo DC-616 - Page 156

154
Chapter 7 6 HELP Mode
S2-Y1540
HELP Mode : 47
1. Function
2. Operating Procedure
(1) Creasing position adjustment
• The creasing position is adjusted.
(1) Creasing position adjustment
1. Set the skew adjusting dial at “0”.
2. Access the HELP Mode “47”, and press the <START> key.
3. Cut the adjustment paper (S2-Y1040) by pressing the <TEST>
key.
* The paper is cut applying the Service person JOB83.
4. Measure the fi nished creasing position.
5. Enter the adjustment value by pressing the NUMERIC key.
The creasing position moves by 0.1 mm when the adjustment
value is changed by 1.
H47
Cut-Crease dist.
Distance:
XXX
SET:Save
REFERENCE
Creasing position is reset to the default value by continuously
pressing the <C> key. (This is not a factory setting.)
6. Press the <SET> key, and store the adjustment information in the
memory.
7. Press the <STOP> key. It will return to the HELP Mode selection
screen.
-0