Duplo DC-616 - Page 160

158
Chapter 7 6 HELP Mode
S2-Y1540
-0
9. Proceed the Service person JOB84 again to check for slitters run
following the adjustment values properly.
The setting of Service person JOB84
MSL: 25 mm
1: 50 mm
2: 50 mm
3: 50 mm
4: 50 mm
5: 50 mm
* If the slitter position is still incorrect, go back to the step 7 and
attempt to re-adjust.
10. Press the <STOP> key. It will return to the HELP Mode selection
screen.