Duplo DC-616 - Page 161

159
Chapter 7 6 HELP Mode
7
S2-Y1540
HELP Mode : 52
1. Function
2. Operating Procedure
(1) Main motor transfer distance adjustment
• Transfer distance of the main motor is adjusted.
(1) Main motor transfer distance adjustment
1. Set the skew adjusting dial at “0”.
2. Access the HELP Mode “52”, and press the <START> key.
3. Cut the adjustment paper by pressing the <START> key.
* The paper is cut applying the Service person JOB 91.
4. Measure the cut paper width.
5. Enter the adjustment value by pressing the NUMERIC key.
H52
Main motor adj.
XXX
.
XX
SET:Save
REFERENCE
The transfer distance will get shorter as the adjustment value
becomes smaller.
The transfer distance will get longer as the adjustment value
becomes larger.
6. Press the <SET> key, and store the adjustment information in the
memory.
7. Press the <STOP> key. It will return to the HELP Mode selection
screen.
Adjustment value is reset to the default value by continuously
pressing the CLEAR key.
(This is not a factory setting.)
-0