93
Chapter 3 9 Main Drive Section
3
S2-Y1540
REFERENCE
REFERENCE
1. Loosen the nut.
Depth adjustment screw
2. Loosen the screw.
3. Loosen the two screws securing the stoppers of the
perforation tool depth adjustment screws. (approx.
3 mm)
First loosen the nut, and then loosen the screws.
4. Raise the perforation tools on both sides up to
the upper limit position with the depth adjustment
screws.
Turn the depth adjustment screws until they stop.
Make sure that the rubber roller of the upper tool is
apart from the lower tool.
If not, loosen the screws securing the stoppers in step
3 more.
Should be apart from the lower tool
-0
To Next Page
Loading...
