Light barriers
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 125
11. Fix the erect template (1) on the left in place on the clamp using a strip
of adhesive tape (2).
12. Press the button.
The needles are switched off.
13. Use the handwheel to turn the needles to the top dead center against
the direction of rotation.
14. Press the button.
The template (1) is scanned.
The display shows the scanned parameters. The scanned parame-
ters are automatically adopted by the control.
Fig. 107: Setting the light barriers for the left and the right flap rest (3)
15. Press the button.
The flap clamp opens.
16. Remove the template (1).
17. Press the button.
The settings are stored, and the display switches to Machine test.
18. Slide the transport clamps to the rear by hand.
19. Swing in the folding station.
20. Switch off the sewing unit.
21. Switch the sewing unit back on.
To Next Page
Loading...
