Stacker
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 165
6. The throw-over bracket (3) swivels out.
The switch (11) prevents the throw-over bracket (3) from swiveling
out too far.
The switch (11) should be pressed (b) = 10 - 20 mm before the piston
rod of the cylinder (12) reaches its end position, thereby causing the
throw-over bracket to start swiveling down.
7. Loosen the screw and adjust the switch cam (10) by turning.
Important
The throw-over bracket (3) should not reach the end position of the
cylinder (12) during the last section of the backward movement. Check the
optimal switch actuation point with workpieces and correct it if necessary.
Fig. 147: Setting the throw-over stacker (5)
8. The throw-over bracket (3) swivels down to its end position.
The switch (14) must be actuated (c) = 6 - 8 mm before the end posi-
tion of the cylinder is reached.
9. Loosen the screw and adjust the switch cam (13) by turning.
Important
If the switch actuation point is set too early, the throw-over bracket (3) may
collide with the clamping bracket (4) during the last section of the backward
movement. Check the optimal switch actuation point by performing stacking
operations with workpieces and correct it if necessary.
Fig. 148: Setting the throw-over stacker (6)
(13) - Switch cam
(14) - Switch
(15) - Cylinder
(16) - Switch (17) - Switch cam
To Next Page
Loading...
