Programming
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 217
Parameters Corner knife (Slanted pocket) (745-35-10 A only)
Important
Before you can set the corner knife parameters for the slanted pocket, you
must select the option Straight/Slanted pocket in the submenu
Corner knife setup in the Machine configuration ( p. 237).
The display switches to Parameters Corner knife (Slanted
pocket).
Fig. 189: Parameters Corner knife (Slanted pocket):
Symbols Meaning
All corner knives On/Off
Corner knife seam begin. left On/Off
Corner knife seam begin. right On/Off
Correction seam begin. left
• -9.9 mm - 9.9 mm
Correction seam begin. right
• -9.9 mm - 9.9 mm
Seam end outer left On/Off
To Next Page
Loading...
