Programming
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 275
Inputs 745-35-10 A
2. Select an output in the right area:
Outputs 745-35-10 S
S1 Needle thread monitor left
S2 Needle thread monitor right
S3 Folder down
S4 Folding station swiveled in
S5 Corner knife swiveled in
S6 Light barrier push-back blocking
S7 Pedal left, forward
S8 Pedal left, backward
S9 Pedal right, forward
S10 Pedal right, backward
S11 Clamp adjustment right
S12 Clamp adjustment left
S13 Pressure monitor
S15 DC Module (DATA OUT)
S17 Light barrier flap scan 1
S20 Light barrier flap scan 2
S21 Tape monitor (tape feeder)
S24 Light barrier flap scan 3
S100 Sewing motor reference
S101 Reference transport unit (X)
S102 Reference knife block seam beginning (Y)
Y1 Open needle thread cutter
Y2 Lower center knife
Y3 Blow out fluff
Y4 Open hook thread cutter
Y5 Close hook thread cutter
Y6 Close thread tension
Y7 Lower left transport clamp
Y8 Lower right transport clamp
Y9 Lift folder off
Y10 Lower folder
To Next Page
Loading...
