ELTEX ESR Series - Page 126

ESR-Series. User manual
126
Step Description Command Keys
8 Specify the IPv4/IPv6 address and
subnet mask for the interface to be
configured or enable IP address obtain
dynamically.
esr(config-bridge)# ip address
<ADDR/LEN>
<ADDR/LEN> – IP address and
subnet mask length, defined as
AAA.BBB.CCC.DDD/EE where
each part AAA-DDD takes
values of [0..255] and EE takes
values of [1..32].
For advanced IPv4 addressing
features see section IP
addressing configuration.
esr(config-bridge)# ipv6 address
<IPV6-ADDR/LEN>
<IPV6-ADDR/LEN> – IP address
and prefix of a subnet, defined
as X:X:X:X::X/EE where each X
part takes values in
hexadecimal format [0..FFFF]
and EE takes values of [1..128].
For advanced IPv6 addressing
features see section IPv6
addressing configuration.
You can specify several IPv4/
IPv6 addresses separated by
commas. Up to 8 IPv4/IPv6
addresses can be assigned to
the interface.
esr(config-bridge)# ip address
dhcp
For advanced DHCP client
operation features, see section
DHCP Client management.
9 Disable the Firewall features on the
interface or enable the interface in the
security zone (see Firewall
configuration).
esr(config-bridge)# ip firewall
disable
esr(config-bridge)# security-zone
<NAME>
<NAME> – security zone name,
set by the string of up to 31
characters.
9 Enable recording of the current
interface usage statistics (optional).
esr(config-bridge)# history
statistics
8 Specify the time interval during which
the statistics on the bridge load is
averaged (optionally).
esr(config-bridge)# load-average
<TIME>
<TIME> – interval in seconds,
takes values of [5..150].
Default value: 5