ELTEX ESR Series User Manual

ESR-Series. User manual
474
esr# show remote-access status openvpn server AP
To view OpenVPN server session counters, use the following command:
esr# show remote-access counters openvpn server AP
To clear OpenVPN server session counters, use the following command:
esr# clear remote-access counters openvpn server AP
To end OpenVPN server session for user 'fedor', use one of the following commands:
esr# clear remote-access session openvpn username fedor
esr# clear remote-access session openvpn server AP username fedor
To view OpenVPN server configuration, use the following command:
esr# show remote-access configuration openvpn AP
15.4 Configuring remote access client via PPPoE
PPPoE is a tunneling protocol that allows encapsulating IP PPP over Ethernet connections and has PPP
connection software capabilities, which allows using it to establish virtual connections to a neighbouring
Ethernet device or a point-to-point connection that is used to transmit IP packets, and also works with PPP
features. This allows applying conventional PPP-oriented software to configure the connection that uses not
serial communication link but packet-oriented network (for example, Ethernet) to organize a classical
connection with login and password for Internet connections. In addition, IP address on the opposite side of
connection is assigned only when PPPoE connection is open, allowing the dynamic reuse of IP addresses.
15.4.1 Configuration algorithm
Step Description Command Keys
1 Create a PPPoE tunnel and switch to its
configuration mode.
esr(config)# tunnel pppoe
<PPPoE>
<PPPoE> – tunnel sequence
number from 1 to 10.
2 Specify the description of the
configured client (optionally).
esr(config-pppoe)# description
<DESCRIPTION>
<DESCRIPTION> – PPPoE
server description, set by the
string of up to 255 characters.
3 Specify the name of the VRF instance
that will use the PPPoE client.
(optional)
esr(config-pppoe)# ip vrf
forwarding <VRF>
<VRF> – VRF name, set by the
string of up to 31 characters.
In addition to OpenVPN server creation, you should open TCP port 1194 in the firewall.


ELTEX ESR Series Specifications

General

Model	ESR Series
Category	Network Router
Manufacturer	ELTEX
Management	Web interface, CLI, SNMP
Operating Temperature	0°C to 40°C
Dimensions	Varies by model
Weight	Varies by model
Routing Protocols	OSPF, BGP
WAN Interfaces	Ethernet, SFP
LAN Interfaces	Ethernet, SFP
VPN Support	IPsec, L2TP, PPTP
Firewall	Stateful packet inspection, ACLs
Power over Ethernet (PoE)	Available on some models
QoS	Traffic prioritization