•
•
•
•
•
•
•
1.
2.
3.
1.
2.
3.
3 Installation and connection
Support brackets mounting
Device rack installation
ESR-1000, ESR-1200, ESR-1500, ESR-1511, ESR-3100, ESR-1700 power module installation
Connection to Power Supply
SFP transceiver installation and removal
Transceiver installation
Transceiver removal
This section describes installation of the device into a rack and connection to a power supply.
3.1 Support brackets mounting
The delivery package includes support brackets for rack installation and mounting screws to fix the device
case on the brackets. To install the support brackets:
Figure 50 – Support brackets mounting
Align four mounting holes in the support bracket with the corresponding holes in the side panel of the
device.
Use a screwdriver to screw the support bracket to the case.
Repeat steps 1 and 2 for the second support bracket.
3.2 Device rack installation
To install the device to the rack:
Attach the device to the vertical guides of the rack.
Align mounting holes in the support bracket with the corresponding holes in the rack guides. Use the
holes of the same level on both sides of the guides to ensure the device horizontal installation.
Use a screwdriver to screw the router to the rack.
To Next Page
Loading...
Need help?
General
