•
•
•
•
•
•
•
The default 'rollback' timer value is 600 seconds. To change this timer, use the command:
esr(config)# system config-confirm timeout <TIME>
<TIME> –time period of configuration confirmation pending, takes value in seconds [120..86400].
5.2.3 Basic router configuration
Upon the first startup, the router configuration procedure includes the following steps:
Changing password for "admin" user.
Creation of new users.
Assigning device name (Hostname).
Setting parameters for public network connection in accordance with the provider requirements.
Configuring remote connection to router.
Applying basic settings.
Changing password for "admin" user
To ensure the secure system access, you should change the password for the privileged 'admin' user.
Username and password are required for login during the device administration sessions.
To change 'admin' password, use the following commands:
esr# configure
esr(config)# username admin
esr(config-user)# password <new-password>
esr(config-user)# exit
Creation of new users
Use the following commands to create a new system user or configure the username, password, or privilege
level:
esr(config)# username <name>
esr(config-user)# password <password>
esr(config-user)# privilege <privilege>
esr(config-user)# exit
'techsupport' account ('eltex' up to version 1.0.7) is required for service centre specialist remote
access.
'remote' account – RADIUS, TACACS+, LDAP authentication.
'admin', 'techsupport', 'remote' users cannot be deleted. You may only change passwords and a
privilege level.
Privilege levels 1–9 allow you to access the device and view its operation status, but the device
configuration is disabled. Privilege levels 10-14 allow both the access to the device and
configuration of majority of its functions. Privilege level 15 allows both the access to the device and
configuration of all its functions.
To Next Page
Loading...
Need help?
General
