EasyManuals Logo

ELTEX ESR Series User Manual

ELTEX ESR Series
575 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #285 background imageLoading...
Page #285 background image
ESR-Series. User manual
285
еsr(config)# interface tengigabitethernet 1/0/2
еsr(config-if)# wan load-balance nexthop 65.6.0.1
In te1/0/2 interface configuration mode, specify a list of targets for connection check:
еsr(config-if)# wan load-balance target-list google
In te1/0/2 interface configuration mode, enable WAN mode and exit:
еsr(config-if)# wan load-balance enable
еsr(config-if)# exit
To switch into redundancy mode, configure the following:
Proceed to WAN rule configuration mode:
еsr(config)# wan load-balance rule 1
MultiWAN function may also work in redundancy mode when traffic is directed to the active interface with the
highest weight. To enable this mode, use the following command:
еsr(config-wan-rule)# failover
11.10 IS-IS configuration
IS-IS — ISO standardized dynamic routing protocol based on link-state. It provides fast convergence and
excellent scalability, makes economical use of network bandwidth, and uses the Dijkstra Algorithm to calculate
the best routes. A distinctive feature of the IS-IS protocol is to work on top of the data link layer of the OSI
model, so it is not binded to a specific network layer protocol.
11.10.1 Configuration algorithm
S
t
e
p
Description Command Keys
1 Create an IS-IS process and
switch to the parameters
configuration mode of this
process.
esr(config)# router isis <ID>
[vrf <VRF>]
<ID> – process number, takes values of
[1..65535];
<VRF> – VRF instance name, set by the string
of up to 31 characters.
2 Set NET address. esr(config-isis)#net {<NET>} <NET> – NET address, format:
ff[.ffff.ffff.ffff.ffff.ffff.ffff].ffff.ffff.ffff.00.
3 Enable IS-IS process. esr(config-isis)# enable

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ELTEX ESR Series and is the answer not in the manual?

ELTEX ESR Series Specifications

General IconGeneral
ModelESR Series
CategoryNetwork Router
ManufacturerELTEX
ManagementWeb interface, CLI, SNMP
Operating Temperature0°C to 40°C
DimensionsVaries by model
WeightVaries by model
Routing ProtocolsOSPF, BGP
WAN InterfacesEthernet, SFP
LAN InterfacesEthernet, SFP
VPN SupportIPsec, L2TP, PPTP
FirewallStateful packet inspection, ACLs
Power over Ethernet (PoE)Available on some models
QoSTraffic prioritization

Related product manuals