ELTEX ESR Series - Page 475

ESR-Series. User manual
475
Step Description Command Keys
4 Specify the interface through which the
PPPoE connection will be established.
esr(config-pppoe)# interface <IF> <IF> – interface or interface
group.
5 Specify user name and password for
connection to PPPoE server.
esr(config-pppoe)# username
<NAME> password ascii-text
{ <CLEAR-TEXT> | encrypted
<ENCRYPTED-TEXT> }
<NAME> – user name, set by
the string of up to 31
characters;
<CLEAR-TEXT> – password, set
by the string of 8 to 16
characters;
<ENCRYPTED-TEXT> –
encrypted password, set by the
string of [16..128] characters.
6 Include the PPPoE tunnel in a security
zone and configure interaction rules
between zones (see section Firewall
configuration).
esr(config-pppoe)# security-zone
<NAME>
<NAME> – security zone name,
set by the string of up to 31
characters.
7 Enable a configured profile. esr(config-pppoe)# enable
8 Specify authentication method
(optionally).
esr(config-pppoe)# authentication
method <METHOD>
<METHOD> – authentication
method, possible values: chap,
mschap, mschap-v2, eap, pap
Default value: chap
9 Enable the opt-out of receiving the
default route from PPPoE server
(optionally).
esr(config-pppoe)# ignore-default-
route
10 Specify the time interval during which
the statistics on the load is averaged
(optionally).
esr(config-pppoe)# load-average
<TIME>
<TIME> – time interval in
seconds from 5 to 150 (5
seconds by default)