ELTEX ESR Series - Page 172

ESR-Series. User manual
172
•
•
Step Description Command Keys
8 Specify the description of the
configured IKE profile (optionally).
esr(config-ike-proposal)#
description<DESCRIPTION>
<DESCRIPTION> – tunnel
description, set by the string of
up to 255 characters.
9 Specify IKE authentication algorithm
(optionally).
esr(config-ike-proposal)#
authentication algorithm
<ALGORITHM>
<ALGORITHM> –
authentication algorithm, takes
values of: md5, sha1, sha2-256,
sha2‑384, sha2-512.
Default value: sha1
10 Specify IKE encryption algorithm
(optionally).
esr(config-ike-proposal)#
encryption algorithm
<ALGORITHM>
<ALGORITHM> – encryption
protocol, takes the following
values: des, 3des, blowfish128,
blowfish192, blowfish256,
aes128, aes192, aes256,
aes128ctr, aes192ctr,
aes256ctr, camellia128,
camellia192, camellia256.
Default value: 3des
11 Define Diffie-Hellman group number
(optionally).
esr(config-ike-proposal)# dh-
group <DH-GROUP>
<DH-GROUP> – Diffie-Hellman
group number, takes values of
[1, 2, 5, 14, 15, 16, 17, 18].
Default value: 1
12 Specify IKE authentication mode
(optionally)
esr(config-ike-proposal)#
authentication method <METHOD>
<METHOD> – key
authentication method. May
take the following values:
pre-shared-key –
authentication method
using pre-received
encryption keys;
rsa-public-key –
authentication method
using RSA certificate.
Default value: pre-shared-key
13 Create an IKE policy and switch to its
configuration mode.
esr(config)# security ike policy
<NAME>
<NAME> – IKE policy name, set
by the string of up to 31
characters.
14 Specify the lifetime of IKE protocol
connection (optionally).
esr(config-ike-proposal)# lifetime
seconds <SEC>
<SEC> – time interval, takes
values of [4..86400] seconds.
Default value: 3600