ELTEX ESR Series - Page 240

ESR-Series. User manual
240
•
•
Step Description Command Keys
21 Set the time interval in seconds after
which the router re-sends a packet that
has not received a delivery confirmation
(for example, a DatabaseDescription
packet or LinkStateRequest packets).
esr(config-ospf- vlink)#
restransmit-interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 5 seconds.
esr(config-ipv6-ospf- vlink)#
restransmit-interval <TIME>
22 Set the time interval in seconds after
which the router sends the next hello
packet.
esr(config-ospf- vlink)# hello-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 10 seconds.
esr(config-ipv6-ospf- vlink)# hello-
interval <TIME>
23 Set the time interval in seconds after
which the neighbor is considered to be
idle. This interval should be a multiple
of the ‘hello interval’ value.
esr(config-ospf- vlink)# dead-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 40 seconds.
esr(config-ipv6-ospf- vlink)# dead-
interval <TIME>
24 Set the time interval in seconds after
which the router selects DR in the
network.
esr(config-ospf- vlink)# wait-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 40 seconds
esr(config-ipv6-ospf- vlink)# wait-
interval <TIME>
25 Define authentication algorithm. esr(config-ospf- vlink)#
authentication algorithm
<ALGORITHM>
<ALGORITHM> –
authentication algorithm:
cleartext – password,
transmitted in
unencrypted form
(available only for RIP
and OSPF-VLINK);
md5 – password is
hashed by md5
algorithm.
26 Set the password for neighbour
authentication.
esr(config-ospf- vlink)#
authentication key ascii-text
{ <CLEAR-TEXT> | encrypted
<ENCRYPTED-TEXT> }
<CLEAR-TEXT> – password,
set by the string of 8 to 16
characters.
<ENCRYPTED-TEXT> –
encrypted password of 8 to 16
bytes (from 16 to 32
characters) in hexadecimal
format (0xYYYY ...) or
(YYYY ...).