ELTEX ESR Series - Page 263

ESR-Series. User manual
263
•
•
Step Description Command Keys
2 Enable BFD for BGP neighbor on the
interface
esr(config-bgp-neighbor)# bfd-
enable
3 Set the interval after which the BFD
message is sent to the neighbor.
Globally
(optionally)
esr(config)# ip bfd idle-tx-interval
<TIMEOUT>
<TIMEOUT> – interval after
which the BFD packet should
be sent, takes values in
milliseconds in the range of
[200..65535] for
ESR-1000/1200/1500/1511
/1700/3100 and [300..65535]
for ESR-10/12V(F)/14VF/
20/21/100/200
By default, 1 second
4 Enable the logging of BFD protocol
state changes (optionally)
esr(config)# ip bfd log-adjacency-
changes
5 Set the minimum interval after which
the neighbor should generate BFD
message.
Globally
(optionally)
esr(config)# ip bfd min-rx-interval
<TIMEOUT>
<TIMEOUT> – interval after
which the BFD message should
be sent by the neighbor, takes
values in milliseconds in the
range of [200..65535] for
ESR-1000/1200/1500/1511
/1700/3100 and [300..65535]
for ESR-10/12V(F)/
20/21/100/200
By default:
300 ms on
ESR-10/12V(F)/14VF/
20/21/100/200
200 ms on
ESR-1000/1200/1500
/1511/1700/3100