ELTEX ESR Series - Page 291

ESR-Series. User manual
291
•
•
•
•
•
•
•
•
•
•
•
•
S
t
e
p
Description Command Keys
2
7
Set the interval for sending hello
packets (optional).
esr(config-if-gi)# isis hello-
interval <TIME> [<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
2
8
Set the multiplier for calculating
and sending Hold Time (optional).
esr(config-if-gi)# isis hello-
multiplier <VALUE> [<LEVEL>]
<VALUE>– number, may take values
[3..1000];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
2
9
Set the interface to point-to-point
IS-IS protocol mode (optional).
esr(config-if-gi)# isis network
point-to-point
3
0
Set the interval for generating and
sending CSNP (optional).
esr(config-if-gi)# isis csnp-
interval <TIME> [<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
3
1
Set the interval for generating and
sending PSNP (optional).
esr(config-if-gi)# isis psnp-
interval <TIME> [<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
3
2
Set the interval between LSP
transmissions on the Broadcast
network (optional).
esr(config-if-gi)# isis lsp-
interval <TIME> [<LEVEL>]
<TIME> – time in milliseconds, takes values
of [1-10000];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.
3
3
Set the LSP re-distribution interval
in the PtP network (optional).
esr(config-if-gi)# isis lsp-
retransmit-interval <TIME>
[<LEVEL>]
<TIME> – time in seconds, takes values of
[1..65535];
<LEVEL> – IS-IS protocol operation level:
level-1 – operate only on level 1;
level-2-only – operate only on level 2.