ELTEX ESR Series - Page 335

ESR-Series. User manual
335
PE3(config)# bridge 1
PE3(config-bridge)# enable
PE3(config-bridge)# exit
PE3(config)# interface gigabitethernet 1/0/4
PE3(config-if-gi)# mode switchport
PE3(config-if-gi)# bridge-group 1
PE3# sh interfaces bridge
Bridges Interfaces
---------- --------------------------------------------------------------
bridge 1 gi1/0/4
PE3# sh interfaces status bridge
Interface Admin Link MTU MAC address Last change
Mode
state state
------------------ ----- ----- ------ ------------------ -------------------------
----------
bridge 1 Up Up 1500 a8:f9:4b:ac:df:f0 1 minute and 21 seconds
Routerport

PE3# sh interfaces status bridge 1
Interface 'bridge 1' status information:
Description: --
Operational state: Up
Administrative state: Up
Supports broadcast: Yes
Supports multicast: Yes
MTU: 1500
MAC address: a8:f9:4b:ac:df:f0
Last change: 1 minute and 24 seconds
Mode: Routerport
Next, perform the VPLS configuration:
PE1:
Switch to the L2VPN configuration context and include the previously created bridge domain.
PE1(config)# mpls
PE1(config-mpls)# l2vpn
PE1(config-l2vpn)# vpls l2vpn
PE1(config-l2vpn-vpls)# bridge-group 1