ELTEX ESR Series - Page 376

ESR-Series. User manual
376
•
•
•
•
•
Step Description Command Keys
6 Set the port number to communicate
with remote TACACS server (optional).
esr(config-tacacs-server)# port
<PORT>
<PORT> – number of TCP port
to exchange data with a remote
server, takes values of
[1..65535].
Default value: 49 for TACACS
server.
7 Prioritize the use of a remote TACACS
server (optional).
esr(config-tacacs-server)# priority
<PRIORITY>
<PRIORITY> – remote server
priority, takes values in the
range of [1..65535].
The lower value, the higher the
priority of server is.
Default value: 1.
8 Set IPv4/IPv6 address that will be used
as source IPv4/IPv6 address in
transmitted TACACS packets.
esr(config-tacacs-server)#
source-address { <ADDR> | <IPV6-
ADDR> }
<ADDR> – source IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values of
[0..255];
9 Set TACACS as authentication method
of user privileges elevation.
esr(config)# aaa authentication
enable <NAME><METHOD 1>
[ <METHOD 2> ] [ <METHOD 3> ]
[ <METHOD 4> ]
<NAME> – list name, set by the
string of up to 31 characters;
default – default list
name.
<METHOD> – authentication
methods:
enable – authentication
by enable passwords;
tacacs – authentication
by TACACS;
radius – authentication
by RADIUS;
ldap – authentication by
LDAP.