ELTEX ESR Series - Page 379

ESR-Series. User manual
379
Step Description Command Keys
7 Specify the interval after which the
device assumes that LDAP server has
not found users entries satisfying the
search condition (optional).
esr(config)# ldap-server search
timeout <SEC>
<SEC> – time interval in
seconds, takes values of [0..30]
Default value: 0 – device is
waiting for search completion
and response from LDAP
server.
8 Specify an attribute name of the object
which is compared with the name of the
desired user on LDAP server (optional).
esr(config)# ldap-server naming-
attribute <NAME>
<NAME> – object attribute
name, set by the string of up to
127 characters.
Default value: uid.
9 Specify the object attribute name which
is compared with the name of a desired
user on LDAP server (optional).
esr(config)# ldap-server privilege-
level-attribute <NAME>
<NAME> – object attribute
name, set by the string of up to
127 characters.
Default value: priv-lvl
10 Set the DSCP code global value for the
use in IP headers of LDAP server egress
packets (optional).
esr(config)# ldap-server dscp
<DSCP>
<DSCP> – DSCP code value,
takes values in the range of
[0..63].
Default value: 63
11 Add LDAP server to the list of used
servers and switch to its configuration
mode.
esr(config)# ldap -server host
{ <IP-ADDR> | <IPV6-ADDR> }
[ vrf <VRF> ]
esr(config-ldap-server)#
<IP-ADDR> – LDAP server IP
address, defined as
AAA.BBB.CCC.DDD where each
part takes values of [0..255]
<IPV6-ADDR> – LDAP server
IPv6 address, defined as
X:X:X:X::X where each part
takes values in hexadecimal
format [0..FFFF]
<VRF> – VRF instance name,
set by the string of up to 31
characters.