ELTEX ESR Series - Page 446

ESR-Series. User manual
446
Step Description Command Keys
esr(config-if-gi)# ipv6 vrrp ip
<IPV6-ADDR>
<IPV6-ADDR> – virtual IPv6
address, defined as X:X:X:X::X
where each part takes values in
hexadecimal format [0..FFFF].
You can specify up to 8 IPv6
addresses separated by
commas.
5 Set the VRRP router identifier. esr(config-if-gi)# vrrp id <VRID> <VRID> – VRRP router
identifier, takes values in the
range of [1..255].
esr(config-if-gi)# ipv6 vrrp id
<VRID>
6 Set the VRRP router priority (optionally). esr(config-if-gi)# vrrp priority <PR> <PR> – VRRP router priority,
takes values in the range of
[1..254].
Default value: 100.
esr(config-if-gi)# ipv6 vrrp priority
<PR>
7 Identify the VRRP router’s inherence to
a group. The group provides the ability
to synchronize several VRRP
processes, so if in one of the processes
there is a wizard change, then in
another process roles will also be
changed (optionally).
esr(config-if-gi)# vrrp group
<GRID>
<GRID> – VRRP router group
identifier, takes values in the
range of [1..32].
esr(config-if-gi)# ipv6 vrrp group
<GRID>
8 Set the IP address that will be used as a
source IP address for VRRP messages
(optionally).
esr(config-if-gi)# vrrp source-ip
<IP>
<ADDR> – sender IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values
of [0..255];
esr(config-if-gi)# ipv6 vrrp source-
ip <IPV6>
<IPV6> – source IPv6 address,
defined as X:X:X:X::X where
each part takes values in
hexadecimal format [0..FFFF].
9 Set the interval between sending VRRP
messages (optionally).
esr(config-if-gi)# vrrp timers
advertise <TIME>
<TIME> – time in seconds,
takes values of [1..40].
Default value: 1 second.
esr(config-if-gi)# ipv6 vrrp timers
advertise <TIME>
10 Set the interval after which
GratuituousARP messages are sent
when switching the router to the Master
status (optionally).
esr(config-if-gi)# vrrp timers garp
delay <TIME>
<TIME> – time in seconds,
takes values of [1..60].
Default value: 5 seconds.