Step Description Command Keys
11 Define the additional parameters for a
specified OpenVPN server user (when
using a local base for user
authentication).
esr(config-openvpn-server)#
username < NAME >
<NAME> – user name, set by
the string of up to 31
characters.
12 Define a subnet for the specified user of
the OpenVPN server.
esr(config-openvpn-user)# subnet
<ADDR/LEN>
<ADDR/LEN> – subnet address,
set in the following format:
AAA.BBB.CCC.DDD/NN –
network IP address with prefix
mask, where AAA-DDD take
values of [0..255] and EE takes
values of [1..32].
13 Define a static ip address for the
specified OpenVPN server user
esr(config-openvpn-user)# ip
address <ADDR>
<ADDR> – address set in the
following format:
AAA.BBB.CCC.DDD – IP
address of the subnet where
AAA-DDD are set to [0..255].
14 Enable OpenVPN server profile. esr(config-openvpn-server)#
enable
15 Enable data transmission blocking
between clients (optionally).
esr(config-openvpn-server)#
client-isolation
16 Set the maximum amount of
simultaneous user sessions
(optionally).
esr(config-openvpn-server)#
client-max <VALUE>
<VALUE> – maximum amount
of users, takes values of
[1..65535].
17 The mechanism of transmitted data
compression between clients and the
OpenVPN server is enabled (optionally).
esr(config-openvpn-server)#
compression
18 Define the list of DNS servers that will
be used by remote users (optionally).
esr(config-openvpn-server)# dns-
server <ADDR>
<ADDR> – DNS server IP
address, defined as
AAA.BBB.CCC.DDD where each
part takes values of [0..255].
19 Specify TCP/UDP port that will be
listened by OpenVPN server
(optionally).
esr(config-openvpn-server)# port
<PORT>
<PORT> – TCP/UDP port, takes
values of [1..65535].
Default value: 1194
20 Enable the default route advertising for
OpenVPN connections, which leads to
the replacement of the default route on
the client side (optionally).
esr(config-openvpn-server)#
redirect-gateway
To Next Page
Loading...
Need help?
General
