Step Description Command Keys
2 Specify the host name (optionally).
For active mode, the name must match
the host name on the zabbix server.
esr(config-zabbix)# hostname
<WORD>
esr(config-zabbix-proxy)#
hostname <WORD>
<WORD> – host name, set by
the string of up to 255
characters.
3 Specify the address of the zabbix
server.
esr(config-zabbix)# server <ADDR>
esr(config-zabbix-proxy)#
server<ADDR>
<ADDR> – server IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values of
[0..255].
4 Specify the server address for active
checks (when using active mode).
esr(config-zabbix)# active-server
<ADDR> <PORT>
esr(config-zabbix-proxy)# active-
server <ADDR> <PORT>
<ADDR> – server IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values of
[0..255].
<PORT> – server port, set in the
range of [1..65535].
Default value: 10051.
5 Specify the port that will be listened by
the agent/proxy (optional).
esr(config-zabbix)# port <PORT>
esr(config-zabbix-proxy)# port
<PORT>
<PORT> – port that will be
listened by zabbix agent/proxy,
may take values in the range of
[1..65535].
Default value: 10050.
6 Allow remote commands execution by
zabbix agent/proxy (when using active
mode).
esr(config-zabbix)# remote-
commands
esr(config-zabbix-proxy)# remote-
commands
7 Specify the address from which the
server will interact (optionally).
esr(config-zabbix)# source-
address <ADDR>
esr(config-zabbix-proxy)# source-
address<ADDR>
<ADDR> – server IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values of
[0..255].
Default value: nearest routing
address.
To Next Page
Loading...
Need help?
General
