ELTEX ESR Series - Page 76

ESR-Series. User manual
76
•
•
•
•
•
•
Interface type Designation
Logical interfaces Designation of logical interface is the interface sequence number:
Designation examples:
loopback 4
bridge 60
service-port 1
Serial interfaces Designation of serial interface includes its type and identifier.
E1 interfaces identifier is as follows: <UNIT>/<SLOT>/<STREAM>,
where
<UNIT> – number of a device in a device group [1..1],
<SLOT> – device module number or '0' if the device does
not consist of modules,
<PORT> – port sequence number.
Designation example: serial 1/0/1
USB modems Designation of USB modem includes its type and sequence number:
modem <MODEM-NUM>
Designation example: modem 1
FXS/FXO ports Designation of FXS/FXO ports includes its type and sequence
number:
interface voice-port <NUM>
Designation example: voice-port 1
1.   Number of interfaces of each type depends on the router model.
2.   The current firmware does not support for devices stacking. A device number in unit device
group can only take the value of 1.
3.   Some commands support for simultaneous operation with the interface group. To specify the
interface group, you may use a comma-separated list or specify a range of identifiers using a hyphen
“-”.
Examples of interface groups specifying:
interface gigabitethernet 1/0/1, gigabitethernet 1/0/5
interface tengigabitethernet 1/0/1-2
interface fortygigabitethernet 1/0/1-2
interface gi1/0/1-3,gi1/0/7,te1/0/1,fo1/0/1
