ELTEX ESR Series User Manual

ESR-Series. User manual
83
•
•
Configuration example for obtaining dynamic IP address from DHCP server on Gigabit Ethernet 1/0/10
interface:
esr# configure
esr(config)# interface gigabitethernet 1/0/10
esr(config-if)# ip address dhcp
esr(config-if)# exit
To ensure the correct IP address assigning for the interface, enter the following command when the
configuration is applied:
esr# show ip interfaces
IP address Interface Type
------------------- --------------------------------- -------
192.168.11.5/25 gigabitethernet 1/0/10 DHCP
Configuring remote connection to router
In the factory configuration, remote access to the router may be established via Telnet or SSH from the
'trusted' zone. To enable remote access to the router from other zones, e.g. from the public network, you
should create the respective rules in the firewall.
When configuring access to the router, rules should be created for the following pair of zones:
source-zone – zone that the remote access will originate from;
self – zone which includes router management interface.

ELTEX ESR Series Specifications

General

Model	ESR Series
Category	Network Router
Manufacturer	ELTEX
Management	Web interface, CLI, SNMP
Operating Temperature	0°C to 40°C
Dimensions	Varies by model
Weight	Varies by model
Routing Protocols	OSPF, BGP
WAN Interfaces	Ethernet, SFP
LAN Interfaces	Ethernet, SFP
VPN Support	IPsec, L2TP, PPTP
Firewall	Stateful packet inspection, ACLs
Power over Ethernet (PoE)	Available on some models
QoS	Traffic prioritization