Epson AcuLaser C1100 - Page 191

EPSON AcuLaser C1100 Revision B
TROUBLESHOOTING FIP according to the printer message 191
FIP-38
 Panel Message
 Jam DM
 Jam C
 Jam D
 Jam LC, G
 Jam E
 Jam D, E
 Jam C, E, F
 Jam D, F
 Possible parts that caused the error
 Troubleshooting
 SENSOR LOW PASS  SENSOR UPPER PASS
 SENSOR T/R  SENSOR OHP
 SENSOR REGI  SENSOR FUSER IN
 EXIT SENSOR (Sensor in Fuser)
Step Check Yes No
1
Check of error/status code
Specify the problem Sensor by the error/status
code:
Jam DM:
SENSOR LOW PASS
Jam C, Jam D:
SENSOR UPPER PASS
EXIT SENSOR (Sensor in Fuser)
Jam LC, G:
SENSOR T/R
Jam E, Jam D, E:
SENSOR OHP
SENSOR REGI
Jam C, E, F, Jam D, F:
SENSOR FUSER IN
Is there paper remaining on the problem
Sensor?
Remove the
remaining paper
and proceed to
Step [2].
Go to Step [3].
2
Does the error recur when a test print is
made?
Go to Step [3]. End of
procedure
3
Operation check (1) of problem Sensor
Does the ACTUATOR move smoothly
without any damage?
Or, is the light emitter of the Sensor clean?
Go to Step [4]. Re-attach or
replace the
actuator, or
clean the light
emitter.
4
Operation check (2) of problem Sensor
The voltage of the common line and signal
line to each Sensor on PWBA MCU is 0 VDC
in a sensor detecting state, or is 5 VDC in a
sensor non-sensing state?
Replace PWBA
MCU. (p.404)
Replace the
problem Sensor.