Epson AcuLaser C1100 - Lv;Hvps

EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY ELEC 407
4.11.6 LV/HVPS
REMOVAL
1. Remove COVER ASSY LH. (p.295)
2. Disconnect all connectors from the LV/HVPS.
3. Remove the 6 screws (silver, with flange, 6 mm) fastening LV/HVPS to the main
unit.
4. Remove the top part of LV/HVPS from the protrusion of the bracket attached to
the main unit while taking out the front side of LV/HVPS from between the main
unit and COVER FRONT L, and remove LV/HVPS.
REINSTALLATION
1. Put the top part of LV/HVPS inside the protrusion of the bracket while inserting
the front side of LV/HVPS in between the main unit frame and COVER FRONT L
to attach LV/HVPS.
2. Fasten LV/HVPS to the main unit with the 6 screws (silver, with flange, 6 mm).
3. Connect all connectors to the LV/HVPS.
4. Attach COVER ASSY LH. (p.295)
Figure 4-111. Removal of LV/HVPS
C A U T I O N
Avoid staticky places such as on a carpet especially when removing
or inserting a Board. Before starting work with the Board, make
sure to touch metallic portion of the printer connected to the earth
to let your body come out free of static electricity.
Leg_Sec03_111EB
500
515
504
(1BTR)
508
(BCR)
509
(DEVE)
(Blue)
502 501
503
2)
4)-1
3)
3)
3)
3)
3)
3
)
4)-2