Epson AcuLaser C1100 - Cover Up-Dup Trans

EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY DUPLEX 437
4.12.21 COVER UP-DUP TRANS
REMOVAL
1. Remove DUPLEX ASSY. (p.412)
2. Remove COVER LOW-DUP TRANS. (p.436)
3. Open COVER UP-DUP TRANS.
4. Bend down the attachment section on the right side of COVER UP-DUP TRANS
with a small screwdriver or a similar tool, draw out the boss on the right side from
the hole on DUPLEX ASSY, and remove COVER UP-DUP TRANS.
REINSTALLATION
1. After inserting the boss on the left side into the hole on DUPLEX ASSY with
COVER UP-DUP TRANS open, attach COVER UP-DUP TRANS to DUPLEX
ASSY while bending down the boss on the right side.
2. Open COVER UP-DUP TRANS.
3. Attach COVER LOW-DUP TRANS. (p.436)
4. Attach DUPLEX ASSY. (p.412)
Figure 4-137. Removal of COVER UP-DUP TRANS
C A U T I O N
When performing the following work, take care not to damage the
COVER UP-DUP TRANS boss.
C A U T I O N
When performing the following work, take care not to damage the
COVER UP-DUP TRANS boss.
Leg_Sec03_136FA
4)-1
4)-2