Epson AcuLaser C1100 - Frame Assy-2 Nd

EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY TRANSFER 346
4.5.3 FRAME ASSY-2ND
REMOVAL
1. Remove COVER ASSY RH. (p.301)
2. Remove CHUTE ASSY-FSR and COVER ASSY-RR 2ND. (p.341)
3. Remove 2ND BTR ASSY. (p.348)
4. Remove PLATE BIAS-2ND ASSY. (p.358)
5. Remove CAM ASSY-2ND. (p.350)
6. Remove SPRING-2ND fastening both the left and right sides of FRAME ASSY-
2ND to the main unit.
7. Remove the E-ring fastening the right-side shaft on FRAME ASSY-2ND to the
main unit, and slide BEARING-BRUSH CAM to the left.
8. Temporarily slide FRAME ASSY-2ND to the right, and draw out the shaft on
FRAME ASSY-2ND from the left-side bearing on the main unit, and remove
FRAME ASSY-2ND together with BEARING-BRUSH CAM.
9. Remove BEARING-BRUSH CAM from FRAME ASSY-2ND.
Figure 4-61. Removal of FRAME ASSY-2ND (1)
C A U T I O N
Step numbers with [ ] in the figure indicate the step of
reinstallation.
C A U T I O N
When performing the following work, take care not to drop or lose
BEARING-BRUSH CAM.
CAUTION
Leg_Sec03_146EB
CAUTION
6)
6)