Epson AcuLaser C1100 - Basic Specifications; Process Specifications & System; Printer Basic Specifications

EPSON AcuLaser C1100 Revision B
PRODUCT DESCRIPTION Basic Specifications 21
1.2 Basic Specifications
1.2.1 Process Specifications & System
 Printing method : Semiconductor laser beam scanning and dry
electrophotographic process with two ingredients
 Light source : Semiconductor laser
 Photoconductor : Organic photoconductor
 Charging : Roller charging system
 Development : Two ingredients
No contact developing system
 Toner : Made up of two nonmagnetic ingredients
 Primary transfer : Intermediate transfer belt method
 Fixing : Heat roller and fuser belt system
1.2.2 Printer Basic Specifications
RESOLUTION
600 dpi
WARMING UP TIME
 37 seconds or less: From turning the power on to ready-to-print status.
(at 22°C, 55% RH, rated voltage, 32MB memory)
 30 seconds or less: From standby mode to ready-to-print status
(at 22°C, 55% RH, rated voltage, 32MB memory)
PRINT MODE
 Color mode : Use four toners (CNYK) to print in full color
 Monochrome mode : Use only black toner (K) and the highest print speed is
available.
PRINTING SPEED MODE
 Color mode (F/C)
 Standard mode : Feed (print) papers at the maximum speed of the color
mode.
 Low speed mode 1 : Feed paper at low speed to maintain fixation when
printing on thick paper over 28 lb (105g/m
2
) (including
envelopes/labels).
 Low speed mode 2 : Feed paper at low speed to maintain fixation when
printing on transparencies.
 Monochrome mode (B/W)
 Standard mode : Feed paper (print) at the maximum speed of the printer.
 Low speed mode : Feed paper at low speed to maintain fixation when
printing on thick paper over 43 lb (163 g/m
2
) (including
transparencies/envelopes).